New Model with great new COOL features!!
The base unit of the cable tester can be connected via a network cable directly to a hub or switch to test wire connections, or to a network card to test the send receive pairs of wires, it can test if there is any open or miss-wire without the remote kit.
8 LEDs to show you exactly which wire is open or miss-wire on both remote and master unit. Old version has 4 LEDs on remote unit.
REMOTE Unit is INCLUDED *Few people asking me about this*
Power Switch on the side, old version has power button on the top of the master unit, easy to press on by mistake and waste battery.
Features: Test the correct pin configuration of 10/100 Base-T 10Basc-2 Thin Ethernet cable, RJ45 modular cables AT & T 258A, TIA-568A/568B, Cat 5, BNC and Token Ring cable, etc
Easy to verify cable continuity, open, short and miss-wire
With remote kit, it can remotely test cable up to 1000 ft in length either on wall plate or patch panel
Can test the grounding
Auto scan with 2 speeds for pin-out indicators
A power switch is provided for saving battery power
Deluxe vinyl carrying pouch included
9 volt battery for power NOT INCLUDED! |
